| Application︰ | SY1013 plug in and socket type power monitor can take the following measurements:
Energy cost, power, using time, total record time.
Display Board 1
1. Current Time (24 hours type)
2. Current Power of the connected electrical device.
3. The cost per hour of the electrical device.
4. Week
Display Board 2
1. System situation displays “ TOTAL COST”
2. Total using time of the electrical device.
3. Total consumed energy of the electrical device.
4. Total cost
Display Board 3
1. System situation displays “TOTAL TIME”.
2. Total record time, to be calculated from the time when the electrical device plugs in energy meter. (RECh)
3. Total using time of the electrical device.
4. The percentage of using time/total record time.
|
| Functions and Features︰ | Under the mode of double price
System sets price 1, while the beginning time of price 1 is time 1.
System sets price 2, while the beginning time of price 2 is time 2.
Energy 1: energy consumed between time 1 and time 2.
Energy 2: energy consumed between time 2 and next time 1.
Total energy cost = price 1 X energy 1+ price 2 X energy 2.
Under the mod of single price
Price 1 and price 2 should be set into the same number.
Total energy cost = Price 1 X Energy 1+ Price 2 X Energy 2.
|
| Structure and Features:︰ | Set system
Press “MODE” “+” “-“ buttons together to enter into the situation of system set. Stop pressing the botton for 5 seconds, and it will quit from this situation automatically.
Set time
1. System situation displayed is “ SET TIME”
2. Press “MODE” button to alter the place, press “+” to add number; press “-“ to minus number.
3. Enter into “SET WEEK” following “TIME SET”, press “+” or “-“ to adjust.
Set unite price of electricity
After you finish the set of time and week, the system will enter into the energy price set situation.
1. System situation displays “SET COST”
2. Enter into the situation of unit price 1 firstly, the screen displays “COST/H1”
3. Set the beginning time of unite price 1, press “MODE” button to change the place; press “+” button to increase the number; “-“ button to reduce the number.
4. Then set the number of unite price 1.
5. Press button “MODE” again to enter into the setting situation of unite price 2, the screen displays “COST/H2”
6. Firstly set the beginning time of unite price 2, press “MODE” button to change the place; press “+” button to increase the number; “-“ button to decrease the number.
7. Then set the number of unite price 2.
|
| Technical Parameters:︰ | Working voltage: 230VAC, 50/60Hz.
Max load: 16A.
Rating voltage: 200-250V (Energy Meter can not work normally beyond this voltage range).
Rating current: 0.00A -16.00A.
Rating power: 5W - 3680W .
Energy display: 0kWh - 9999kWh.
Max bit for time: 9999 hours.
|
|
|
Product Image
|
